All it takes are a few simple steps:
1. Cut out a fabric circle approximately twice the diameter of the button cover.
2. Place the fabric printed side facing down in the button-cover mold.
3. Push the front half of the button rounded side down on top of the fabric.
4. Tuck the edges of the fabric into the center, and then press the button back into it until it is firmly encased.
5. Thread the paperclip through the shank of the button until the button rests at the top rounded edge.
6. Hot glue in place. I dabbed hot glue around the shank area and also where the edges of the button back rest on the paperclip.
Source: http://quiverfullofblessings.com/category/craftdiy-ideas/
No comments:
Post a Comment