After making yesterdays post about making your own bracelet display someone asked if I had one for the headbands. I didn't have one so I made one this morning.
The cuts of PVC needed for the headband display are as follows:
4 ~ 2 inch
2 ~ 3 inch
8 ~ 7 inch
1 ~ 9 inch
1 ~ 11 inch
1 ~ 13 inch
The assembly is the same except the upright are longer to allow for the headbands being longer. Here is a picture of the two displays side by side. The bracelet display is partially painted. When it warms up today I will finish my spray painting.